可燃性氣體檢測與報警系統的外文翻譯--使用無線的可燃氣體檢測系統的設計

1、 本科畢業論文 本科畢業論文(設計 設計)外 文 文 獻 翻 譯譯文題目： 譯文題目： Design of detection of combustible gas and alarm system 學生姓名： 學生姓名： 專 業： 業： 指導教師： 指導教師：

2、 2013 年 2 月第 2 頁The slave part mainly complete data collection and wireless transmission. The master part mainly complete receiving data, displaying and sending alarm message.The signal of gas conc

3、entration is collected by combustible gas sensor which generates a weak electrical signal. The signal can be amplified and stabilized by conditioning circuit. And then A/D circuit converts the analog signal to digital

4、signal which microcontroller can process. In order to improve the measurement accuracy, and reduce the impact of temperature, design a temperature compensation circuit to collect tempreture data. AT89S52 process the c

5、ollected data and send data to the master by wireless transceiver.The master receives the data and displays it by LED. And if the gas concentration being abnormal,the system will drive speaker for an alarm signal and us

6、e TC35i module to send alarm information to user’s mobile. Hardware design Signal Signal acquisition acquisition and and conditioning conditioning circuit. circuit. Figure 2 shows data acquisition circuit. TGS813 is a

7、Gas sensing resistive sensor. The conductivity of TGS813 is influenced by the concentration of combustible gases in air, the greater the concentration, the higher conductivity. In system R0, R9, R10 and RS (in TGS813)

8、form a bridge circuit to convert resistance to voltage signal. Operational amplifier A connected as a voltage follower with resistors R7 and regulator D1 make up the voltage regulator circuit to supply power for the br

9、idge. In order to the voltage adapt to the A/D converter, the voltage is amplified by opamp B, and the magnification can be adjusted through resistor R11. Fig. 2 Gas concentration signal acquisition circuitFig. 3 Temper