工廠精確拉尺校正-integratedmarketing

1、FAC calibration for wheel balancer,Editor: Song Zhi Checked：Li Chuanhong,Version：A1001,Date：2010.10.21,The factory calibration program can be suitable for CB448 and CB460B.,FAC calibratio

2、n for truck wheel balancer,Step 1: Power on the machine and install the 14” car tire on the wheel balancer then input the three parameter （dis/br/dia）of the tire. Step 2: Calibrate ----car tire DYN balance modelPress

3、 the ENTER button ,There shows “P” on the left display.,Preparing work,100g lead,22.5” tire,14” tire,,,FAC calibration for truck wheel balancer,Press “Dis+” to enter “

4、SET –UP” Press “ENTER” to enter “IN–TES ”Then press “ENTER” to enter “POS” “XX”,FAC calibration for truck wheel balancer,Rotate the tire by hand slowly and the PO

5、S value will change.When there’s 110, Press key.Then continue to pull the tire and when there’s 120, press the key.,FAC calibration for truck wheel balancer,It will show the

6、 display “ADD”--” 0” like the following picture, then press the ” START” key.,There will show “ADD”--”100” like the left picture after the tire stopped to rotate.,FAC calibration for truck

7、 wheel balancer,Pull the tire till the indicator light all shine,then put the 100g weight on the rim outside 12 o’clock place.

8、 Then press “START” key to run the machine for calibration.,,,FAC calibration for truck wheel

9、balancer,There will show “100”--”ADD” on the display like below picture after the tire stopped to rotate.

10、 Then remove the 100g weight.Pull the tire till the inside indicator light all shine then put the 100g weight on the rim inside 12 o’clock p

11、lace.,FAC calibration for truck wheel balancer,Press the key to run machine and there will show “SAU”—”dAt” on the display when the tire stops.,The Factory Self-calibration for car tire

12、is finished.,Because the CB460X and CB448X have two balance model ( for car tire and for truck tire), it must be calibrated under car tire balance model firstly and then calibrate under truck tire balance model to ensure