版權說明:本文檔由用戶提供并上傳,收益歸屬內容提供方,若內容存在侵權,請進行舉報或認領
文檔簡介
1、 Physics Procedia 25 ( 2012 ) 2190 – 2196 1875-3892 © 2012 Published by Elsevier B.V. Selection and/or peer-review under responsibility of Garry Lee doi: 10.1016/j.phpro.2012.03.369 2012 International Confe
2、rence on Solid State Devices and Materials Science Data Acquisition and Transmission System Based on Short Message Service Sugwon Kim,S.L. Cockcroft Abstract The data collection and transmission system based on single c
3、hip microcontroller (SCM) uses the LCD screen to display the real-time data, and employs the button matrix as the interactive interface to enter the preset alarm value, the target cell phone numbers and the control sig
4、nals. TC35i is used as the GSM module to transmit data and control information. The alarm short message (SMS) will be sent automatically when the data exceeds the preset alarm value. And user also can order the SCM to
5、send the real-time data and complete the remote control by sending a SMS of specific format. © 2011 Published by Elsevier Ltd. Selection and/or peer-review under responsibility of [name organizer] Keywords: Short M
6、essage Service Wireless Data Collection Transmission System Wireless Monitoring 1. IntroductionAt present, RCD (Residual Current Device) widely used domestic is the electronic ones of fault current operated type. T
7、heir operation depends on the detection and judgment of the electrical parameters of the protected circuit. Because of the complicated application condition of RCD, there are a lot of potential safety hazards for the p
8、ower lines. And abnormal operations are likely to cause equipment damage and property losses. Therefore, automatic control and remote monitoring are required. The operator can readily acquire the operating status of eq
9、uipments and control them. With the continuous development of wireless communication technology, there is increasing demands of industrial control for the wireless monitoring. Wireless transmission technologies widely
10、used today include microwave, Bluetooth, infrared, etc. The transmission distance of microwave is dependent on the weather and other conditions, and the cost of establishing their own base station is quite high. Thus i
11、ts application on the wireless monitoring is * Sugwon Kim, , Woman (1964.6-) School of Information Engineering ,Professor Master Instructor, Research direction: intelligent appliances, intelligent control of MCU Avail
12、able online at www.sciencedirect.com© 2012 Published by Elsevier B.V. Selection and/or peer-review under responsibility of Garry Lee Open access under CC BY-NC-ND license.Open access under CC BY-NC-ND license.a Divi
13、sion of Advanced Materials Engineering, RCIT, Chonbuk National University, Jeonju 561-756, Republic of Korea b Department of Materials Engineering, University of British Columbia, Vancouver, Canada2192 S. Kim et al.
14、 Physics Procedia 25 ( 2012 ) 2190 – 2196 Fig.2 Data acquisition circuit B. GSM Module The Siemens TC35i is used to send and receive short messages. As a GSM module, TC35i series are the first choice of industrial
15、 control level for their cost-effective and upgrading to GPRS module easily. This module can be connected directly with the SCM and also supports RS-232 serial communication. The test format and today’s mainstream PDU
16、(Protocol Data Unit) format can be used to send and receive SMS through this module. In this design, interfaces connected with SCM mainly include IGT (Fire Wire), RXD and TXD. SIM card pins are directly connected with
17、the TC35i pins of the same name via SIM card reader. CCIN pin of the ZIF block connector is used to detect whether the SIM card is inserted properly. The level of CCIN pin is high if the connection is correct, otherwis
18、e low. In addition, the power supply of the module should also be paid attention to. It will power off automatically if the voltage is below 3.3V. Since the power will become larger when sending SMS, the power supply f
溫馨提示
- 1. 本站所有資源如無特殊說明,都需要本地電腦安裝OFFICE2007和PDF閱讀器。圖紙軟件為CAD,CAXA,PROE,UG,SolidWorks等.壓縮文件請下載最新的WinRAR軟件解壓。
- 2. 本站的文檔不包含任何第三方提供的附件圖紙等,如果需要附件,請聯系上傳者。文件的所有權益歸上傳用戶所有。
- 3. 本站RAR壓縮包中若帶圖紙,網頁內容里面會有圖紙預覽,若沒有圖紙預覽就沒有圖紙。
- 4. 未經權益所有人同意不得將文件中的內容挪作商業或盈利用途。
- 5. 眾賞文庫僅提供信息存儲空間,僅對用戶上傳內容的表現方式做保護處理,對用戶上傳分享的文檔內容本身不做任何修改或編輯,并不能對任何下載內容負責。
- 6. 下載文件中如有侵權或不適當內容,請與我們聯系,我們立即糾正。
- 7. 本站不保證下載資源的準確性、安全性和完整性, 同時也不承擔用戶因使用這些下載資源對自己和他人造成任何形式的傷害或損失。
最新文檔
- 外文翻譯--基于短消息服務的數據采集與傳輸系統(英文).pdf
- 外文翻譯--基于短消息服務的數據采集與傳輸系統(英文).pdf
- 外文翻譯--基于短消息服務的數據采集與傳輸系統
- 外文翻譯--基于短消息服務的數據采集與傳輸系統
- 外文翻譯--基于短消息服務的數據采集與傳輸系統(譯文)
- 外文翻譯--基于短消息服務的數據采集與傳輸系統(譯文).doc
- 外文翻譯--基于短消息服務的數據采集與傳輸系統(譯文).doc
- 外文翻譯--基于應用的gsm短消息業務(英文)
- 基于GSM短消息的溫度數據采集與無線傳輸系統的研究與設計.pdf
- 外文翻譯--基于應用的GSM短消息業務(英文).pdf
- 外文翻譯--基于應用的GSM短消息業務(英文).pdf
- 基于GSM短消息的振動數據采集系統設計.pdf
- 基于GSM短消息的無線數據采集系統的設計.pdf
- 基于ARM平臺和GSM短消息的電機數據采集系統.pdf
- 外文翻譯--基于應用的gsm短消息業務
- 外文翻譯--基于應用的gsm短消息業務
- 外文翻譯--基于應用的gsm短消息業務(譯文)
- 外文翻譯--基于lwip協議的海洋數據采集與傳輸系統研究
- 基于.net框架的短消息服務系統的設計與實現
- 基于Web Services的短消息信息服務系統.pdf
評論
0/150
提交評論